Rubber. Determination of 5-ethylidenenorbornene (ENB) or dicyclopentadiene (DCPD) in ethylenepropylene-diene (EPDM) terpolymers1 Scope This International Standard specifies the methods to be used to determine the content of 5 ethylidenenorbornene (ENB) or dicyclopentadiene (DCPD) in ethylene propylene diene (EPDM) terpolymers in the 0,1 % to 10 % range. ENB and DCPD are dienes introduced into ethylene propylene rubbers to generate specific cure properties. Since high precision for diene content determination is important, a Fourier transform infrared spectroscopic (FT IR)

Wiles Greenworld offer a complete business solution by focussing on customers and their needs

Why should you use BS EN 601 - Chemical composition of castings for use in contact with foodstuff

In practice this resulted in cases of similar terminology being used to define different concepts

used for the measurement of high voltages during laboratory and factory tests with direct voltage

Correspondence between ISO/IEC standards and EN standards

Mutual isolation between system outlets

humidification and dehumidification loads and the system heating

The Technical Report CEN/TR 15276-2:2009 has been revised and published as a standard

This standard is not applicable to larger examples of wrapping machines designed to handle products higher than 400 mm and wider than 400 mm

BS EN 295-6 on VCP manholes and inspection chambers is useful for:

Rated capacity limiters and indicators - General requirements

The extent of application of these requirements depends on the organization’s operating environment and complexity