Shrink chuck 4,5° SK 40 - 12 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

With clamping screws

B4 - 25 x 16 x 30

in wooden box 701

Collets sealed for high pressure cooling 120 bar

Cone and flange hardened and grinded

Stem diameter: Ø 8mm h6

Rotationsrichtung: Uhrzeigersinn

WrenchWarranty cardInstruction manualCalibration certificate

- Determining the reference points (calibration) of optical presetting devices

Rotary holder for clamp holders with coolant supply directly to the cutting edge and for ISO clamp holders with claw clamping for optimum cooling of the cutting edge

suitable for limited space

Protection of the measuring unit takes centre stage