Specification for wrought aluminium and aluminium alloys for general engineering purposes - rivet, bolt and screw stock1 Scope This British Standard specifies requirements for rivet stock of diameter up to and including 25 mm made from one grade of aluminium and from four aluminium alloys in various conditions, and for bolt and screw stock of diameter up to and including 12 mm made from four aluminium alloys in various conditions. NOTE The titles of the British Standards referred to in this standard are listed on page 2.

Subclause 5

Despite certain advantages for intentional interchangeability for dose chambers designed for different needle-free injection systems

Annex E (informative) Expressing metadata schemas and application profiles

In order to carry out ecodesign in a systematic and manageable way

these are also described

NOTE: Once this standard is published in the EU Official Journal (OJEU) under Directive 2014/68/EU

020 mg/l water extract

This document is applicable to all international space projects involving:

success/failure format

and their meaning

PD CEN/TS 17307 is an international standard used for Material derived from End-of-Life tyres that specifies the test methods which helps in classifying the Elastomers in the end of life tyres

BS EN 13832-3 on  requirements for prolonged contact with chemicals to protect footwear is useful for: