Arduino Nano Sensor Shield Nano I/o Expansion Board Prototype ShieldFeatures Of Prototype Shield I O Expansion Module Extension Board For Arduino Nano V3. 0: Power Jack, Power LED Reset Button FTDI 4 pins jack Standard Arduino pins More GVS extended pins. Increased DC Power supply Interface Specifications Of Multi Function Funduino Nano Shield Arduino Nano Sensor Expansion Board: 14 I O Pin (servo type with GND, power, and signal) 8 analog Pin with power output and GND 6 PWM Pin 1 Servo power input I2C expansion Pin

Gigabit Ethernet

generic WiFi-BT-BLE MCU module that targets a wide variety of applications

Wide operating temperature range: -30°C to +60°C

Small current:6uA

800 x 480 Resolution

Each module contains one driver and one receiver

this is the original Raspberry Pi Zero W from Raspberrypi

The STM32 Nucleo boards do not require any separate probe as they integrate the ST-LINK/V2-1 debugger and programmer

10Cm Hole To Hole Jumper Wire Dupont Line 40 Pin Arduino Jumper Wire also named as female to female jumper wire is very useful while prototyping electronics circuit

Package weight: 0

Samsung Galaxy A3 (2017)

Controlled by AT Command (3GPP TS 27