Strip Series B540™ | Quick Start GuideAccess to this course will expire on September 1, 2026. This course is designed for the individual student. For training and certifying a group of students, please submit your request here. This quick start is intended to help you get your machine set up and ready to start processing wire.

Spend 2 hours with one of our experts learning about our Cut

to what extent each factor affects the end result

You'll add processing elements and operations for creating complex wire programs

loading wires

ON is the operating software built into all new generation Schleuniger cut & strip machines

New to crimping

PowerStrip 9580 Training - Basic is recommended as a prerequisite

This course is not intended to cover all capabilities of CAYMAN but will give you an introduction to the basic programming steps

so you have full control over the entire production process

How good are your crimps

Automatic measurements can be taken in a fraction of the time required with manual measurements therefore efficiency is significantly increased when using CrimpLab  Automatic software

This is a 1-day (8 hour) session with one of our experts tailored to your needs