Kidde FX-IDC1B Analog ModuleThe FX IDC1B connects a normally open, alarm, supervisory, or monitor type dry contact initiating device circuit (IDC) to the Kidde control panel. This module is for Class B circuit operation. The device address is set using the two rotary switches located on the front of the module. One device address is required. The module is configured to operate as an alarm latching device type from the factory. When the NO contact of an initiating device is

such as RF interference and dust accumulation

use of 4009 IDNAC Repeaters extends the IDNAC SLC with an additional 3 A of SLC current and up to 139 unit loads of additional supervisory capacity

Other Plain or ALERT-printed models provide clear lenses for use with color lens strobe attachments (amber

including silencing and resetting

NOTE: Replaces MG4B

125 mA at 16 VDC in alarm

24 VDC operation with switch selection for free-run or synchronized flash rate

400 series direct wire detectors and sounder bases

while providing end-to-end supervision of the entire audio path

The APS2-6R provides three 24 VDC output circuits

Each switch with one LED

— XP5-C Transponder