Fibre-reinforced plastics. Methods of producing test plates - Compression moulding of SMC and BMC1 Scope This part of ISO 1268 specifies the general principles and procedures for the compression moulding of test plates from two types of fibre reinforced thermosetting moulding compound: sheet moulding compound (SMC) and bulk moulding compound (BMC). The aim of this part of ISO 1268 is to ensure the preparation of flat test plates from which test specimens can be cut (for the relevant test methods, see Annex A). The plates are produced in such a

BS EN 1993-1-2 describes the principles

Safety requirements for medical electrical systems

Hence it is also called a metal–oxide–silicon transistor

With obedience and compliance to BS EN 13311-1

and conditioning of test specimens of ACC and LAC

b) lifting appliances such as paternosters

830 | ISO/IЕС 11586-1 shall complete the proforma as part of the conformance requirements

Manufacturers and designers of hearing aids

Manufacturer of electronic displays

When applicable the present section follows ISO/IEC ISP 10609-1

Packages with intended shipping position

Sharing best practice examples