Slip ClutchThis slip clutch can be attached to any finishing motor with a 1 4" shaft and enables you to stop the rod without stopping the motor during Flex Coat application. This is essential for rod inspection and important touch ups with high speed motors of 60 to 200 rpm. It also makes coating guides with under wraps a snap. The Flex Coat Slip Clutch is used by many of the high production rod manufacturers.

Large 12 cc syringes come filled and ready to use

Let lure or fly rotate for one hour to allow the finish to thicken

Foot Control

This effect is caused by the iridocyte crystal cells in the dermal layer of fish skin

The bottom edges of the bit have been ground to become the cutting edges and the pilot will be masking tape arbors wound onto the shank of the bit below the cutting edges

each with their own advantages: Method 1 - Pour the clear epoxy mixture out onto a flat foil covered surface and add a small amount of glitter

F1K 24cc Loaded Syringe Kit

thinner coats

SKU Description XC1 Micro-Sheer Clippers XP1 Micro-Sheet Pliers

Method 2 - Brush a thin coat of mixed epoxy finish without glitter on the surface of the lure or fly to be coated

the red center stripe is useful for alignment purposes

alignment board