ROTTLER (Precision Counterboring and Finishing) cutting insert 9.52 mm - radius 0.4RT321F (Precision Counterboring and Finishing) A 3 8 (9. 52 mm) IC triangular, uncoated insert with a 1 64 (. 4 mm) cutting radius. Gives the best finish results when machining precision counter bores often machined in diesel engine blocks. The 1 64 (. 4 mm) radius should be used when machining to a step where the mating part requires a smaller radius to eliminate an interference problem. If you are machining a long bore where the spindle must be

8 grinding wheels Ø 52

60° and 90° inclinations can be achieved with this stand

Spindle diameter

50÷700 rpm

COMEC Dress-diamond M10x50 for RV516

they are mainly used on very hard seats and cut very rapid

Test Rotor:This is the same test rotor that is used during the factory machine calibration process

This machine can contain heads and blocks up to 1350 mm of length

Set of 12 pcs

storage and loading fixture (for rapid spindle exchange)

Swing arm control panel

120 dB (2000/14EC) Electrical connection (phase/V/Hz) 1