RaceQuip Seat Belt AdjusterRaceQuip offers various hardware pieces for auto racing seat belt and racecar harness installation. All RaceQuip seat belt mounting hardware is forged from premium quality SAE 1050 steel, then cadmium plated for corrosion resistance. This 2" wide 3 bar slide is designed to slide onto the belt along with a bolt on or snap hook end to secure the hardware in place. These are also necessary to create a loop on the end of the belt for wrap around mounting.

This results in increased maximum potential power output

This kit includes a 30" flat bar for the top and a 35" flat bar for the bottom

168 tooth ring gear with double-sided welds for added strength and comes with SFI 29

These one-piece pushrods are manufactured from high quality 4130 Chromoly steel tubing that has been surface hardened for maximum durability

zinc plated steel sleeves

This is critical as it properly locates the sway bar and prevents lateral movement during hard cornering maneuvers The SB049 attaches to your Sixth Gen Camaro with polyurethane bushings

Several characteristics make the 14063 Performer Series 600 CFM electric choke black powder coated carburetor an outstanding street performer

Made with high-quality 6061 aluminum and comes with rubber pads to secure the pumps in place

Replace the rubber factory rear end housing bushings with a polyurethane setup from UMI

with all the adjustability needed for any for of driving

20x9 0 offset wheel NOTE: Use of Auto 4 HI feature not recommended

The low resistance results in less loss in spark energy so more reaches the spark plug