Buildings and civil engineering works. Sealants. Determination of change in mass and volume1 Scope This document specifies a method for the determination of the change of mass and the change of volume of self levelling and non sagging sealants used in joints in building construction. NOTE This test procedure is not intended to determine the absolute maximum value of loss of volume of a tested sealant, but it is an indicative measurement of the loss of volume under specified parameters.

What is BS 7190 – Thermal performance of hot water boilers using a test rig about

the term “% (m/m)” is used to represent the mass fraction (ω)

This document is for the benefit and use of both CSPs and CSCs

Prior to the first occupancy

Information is presented to enable such an instrument to be constructed

Elements to which this test method applies are listed in Table 1

The revised method requires the conditioning of four specimens in two pairs on two separate test runs

BS 3539 covers the requirements for the meters and assists with the procedure for laboratory verification for sound level meters

BS AU 217-2 discusses maximum road speed limiters for motor vehicles

Shape and dimensions of test pieces

the guidelines of ISO/TR 24498 enable you to verify the consistency of test methods used for paper

occupants and cargo