Joint fillers and sealants - Specifications for hot applied sealants1 Scope This document specifies requirements for hot applied normal and fuel resistant joint sealants to be used in roads, airfields and other trafficked areas. The specification also applies to hot applied normal joint sealants in bituminous surfacing and between bituminous surfacing and concrete pavements.

ISO 9241-220

BS 799-5 specifies requirements for the construction and testing of static carbon steel tanks for the storage of liquid fuel of classes A2

BS EN ISO 14647:2016 supersedes BS ISO 14647:2000 which has been withdrawn

horizontal or vertical) and for each of the bearing locations

the internal architec tur e of a MediaServer devic e is vendor specific

dash lights

The provisions stated in this standard are intended for the designer

Electrotechnical equipment manufacturers

BS EN 61523-1 provides a marked improvement over design environments with no such standards

the manufacturer’s declared values

the standard can be used as a basis to design application specifications relative to an Application Domain

crotonaldehyde in the concentration range of approximately 10 μg/m³ to 1 mg/m³ (see ISO 16000-3)