Information technology. Radio frequency identification for item management - Reference architecture and definition of parameters to be standardized1 Scope 1. 1 This part of ISO IEC 18000 defines the generic architecture concepts in which item identification may commonly be required within the logistics and supply chain and defines the parameters that need to be determined in any standardized air interface definition in the subsequent parts of ISO IEC 18000. The subsequent parts of ISO IEC 18000 provide the specific values for definition of the air interface parameters for a particular frequency

ISO 10320 on ‘geosynthetics on site identification’ is useful for:

BS EN IEC 63103 defines and describes methods of measurement of electrical power consumption in non-active mode(s) for lighting equipment

This International Standard specifies methods for evaluation of sampler performance in terms of workplace conditions: wind speed

output current

ISO/TR 19838 gives general guidelines to explain the use of ISO cosmetic microbiological standards depending on the objective (in-market control

The front page of BS 9220 contains as a minimum the information required by BS 9220

protected by the type of protection: Flameproof enclosure "d"

The numbering of its clauses corresponds to that of ISO 8820-1

are not included

This part of EN ISO 10882 provides guidance for the determination of personal exposure to gases and vapours in welding and allied processes

up to almost 40 % of positive samples would not have been detected (i

and immunity of passive fibre-optic components to the problems associated with electromagnetic interference (EMI)