R2CC-200-200 Re-Machinable Set Screw Shaft CouplingThese unique two piece rigid clamping couplings come with an undersized ID. Allows you room to re bore the ID without damaging the clamp screws. Pilot bore can be opened to the nominal ID reflected in the part number. View Catalog Page

Provides greater axial holding power than set screw collars

High axial load and torque capacity and does not mar the shaft

Tolerates -5° to 220° F

Adapters eliminate the need for complete shaft replacement

USDA & FDA approved

Design fully engages the thread for secure locking

Traditional cost effective rigid coupling design

Entire unit is UHMW-PE

Self-lubricating ideal for wet or harsh environments where wash down is required

Extra thick non-conductive rubber liner corrects misalignment up to 2° while reducing noise & vibration

Allows you room to re-bore the ID without damaging the clamp screws

Two-Piece Housing has rust-proof plated finish