Clipper M-2B Fan Assembly Upgrade KitThis assembly upgrades the Clipper M 2B from a 13 16 shaft to a standard 3 4 shaft. It includes the fan, fan shaft, two pillow block bearings, two angle iron mounts, and a bore step pulley. This eliminates the older cast iron Bridgetree mounts and the 13 16 bearing. Note: the fan will come assembled and this will require you to disassemble the cleaner and remove one of the metal sides to install the fan correctly. 3 week lead time.

Cable Clamp/Rope Clamp

Usually on the bottom blast fan

Dimensions:  11”W X 8” deep x 12” high

This step pulley is ¾” bore and has a 3”

This H-Frame brush carrier holds the brushes under the screens and rides back and forth on the brush carrier shafts to keep the screens clean

75” inches wide 6” long

Clipper M-2B Auger Assembly

The bore size is 1 3/16”

This clipper shoe hanger is used on various clipper models

* safety shields for all belts

These screens will also fit Clipper 2b

This is the boot for the clipper M-2B auger