Set of Hammers for CS Bell Hammermills, models 10 / 20 / 30Set of Hammers for C. S. Bell hammer mills Model 10 = 12 hammers (rows of 4 2 4 2) Model 20 = 18 hammers (rows of 5 4 5 4) Model 30 = 30 hammers (rows of 8 7 8 7) See drawing in photos. Individual hammer dimensions are: 4 long x 1 wide x thick Hole diameter is 13 32. Heat treated for hardness and long life. Balanced per set. Extended life hammers. Hammers are able to flip 4 different directions for extra life and wear.

These bearings are for the standard shaker conveyor that goes under many different Clipper grain and seed cleaners

It may fit other clipper models as well

These are the thick wall roller

and 68D are all 2 ½ screen cleaners so 5 brushes are needed to put all new brushes in the machine

v=j5Bz-5LQN9w&t

24" wide at widest point

Standard screen with WIRE MESH (rectangular or square)

please email us

The shaft length is 28

This pulley is used on all Eliminator 224 & Clipper M-2B seed cleaners to driver the brush drive system

This clamps onto the cable and it sits in the crows foot of a clipper H frame brush carrier

In the manual it says B34