Carbonaceous materials used in the production of aluminium. Prebaked anodes and cathode blocks - Determination of flexural strength by the four-point method1 Scope This part of ISO 12986 specifies a four point method to determine the flexural strength of carbon and solid graphite materials at room temperature. NOTE This part of ISO 12986 is based on DIN 51944.

BS EN 2591-6405 on the method to test optical connector endurance of axial loads is useful for:

Examples of common NDTindications are given in an informative annex

BS ISO/IEC 24703:2004 specifies the datatype of participant identifiers in learning

This concentration of chemicals on a part of the surface is one of the major causes of accelerated uneven soiling of textile floor covering

two or three dimensional structure

It gives recommendations and guidelines that relate to the selection of equipment and pre installation

or utilizing a system based upon alloy type

1   This European Standard covers the grades of wrought steels and alloys listed in Table 1 and Table 2

when tested in accordance with test 2B (bottom edge ignition) of BS 5438:1989

If more than one term applies to a definition

Pin hole test

Figure 1 – Defining the conditioned zone in a cold-roof building