Inside micrometer | digital | 75-100mm with data output | IP 65Construction: Resolution: . 00005" 0. 001mm Designed for the measurement of intricate internal characteristics cartide tipped measuring sufaces Satin chrome finished 5 30mm and 25 50mm range are supplied with setting rings Ratchet stop Delivery: S wrench Warranty card Instruction manual Calibration certificate LR44 1,5V Battery

Bed height H: 0

Measuring contact points are designed to allow measurements near to the bottom of blind holes

Setting angle: 93°

Delivery with test certificate All holders are made of forged steel

Dial face dia

without the illustrated cutting tools

For setting the tool in the HKS collet chucks

quick and simple measuring of the clamping force of hydraulic chucks

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

For mounting straight-shank tools for woodworking in collets

Applicable up to 100 bar

bei Ø 6 – Ø 32 mm = h238