Tissue paper and tissue products - Determination of optical properties. Measurement of brightness and colour with D65/10° (outdoor daylight)1 Scope This part of ISO 12625 specifies testing procedures for the instrumental determination of brightness and colour of tissue paper and tissue products viewed under outdoor daylight conditions. It also gives specific instructions for the preparation of test pieces (single ply, multi ply products) and for the optical measurements of products, where special precautions may be necessary. NOTE The properties called C 2 brightness and colour are

the effect of any test equipment failure on the reliability of the I&C systems is considered

BS EN 62137-1-2 informs that the mechanical properties of the joint between a terminal to land on a printed wiring board using lead-free solder are not the same for the joint using tin-lead solder due to the difference in composing elements of the solders

PD ISO/IEC TR 27019:2013 is currently being revised

similar problems can arise

directional test methods

Contents of BS EN 15850:

required characteristics and test methods that allows you to standardize the production of cables and achieve consistency and performance

The number of aged concrete structures has been increasing all over the world

BS 1202-2 is the second part of the BS 1202 series that focuses on copper nails and their type

BS EN 876:1995 Destructive tests on welds in metallic materials

specifically engineering drawings

What is BS EN 9101 - Quality Management System about