10 Inch Rack Mount for Philips Hue Bridge3D Printed 1RU rack mount for the Philips Hue Bridge. Now in a design to suit 10 Inch Racks! The Bridge slides into the frame from the front. This listing is just for the Hue Mount, other photos showing Blanks etc are just for example. Does not include Rack Screws, Cage Nuts, or Network equipment. The 10 Inch range is expanding, so if you don't see a mount for your equipment let me know and I can prioritize designing one for you. Do you need to have

The Gateway slides into the frame from the front and can either have it's ports facing forwards or backwards

The Switch slides into the frame from the back and then is secured with the Back Plate

"Gateway Max" (Model: UXG-Max) or "Cloud Gateway Max" (Model: UCG-Max) and a Cloud Key Gen2 (UCK-G2-BASE

The MS-01 or MS-A2 slides into the frame from the rear and is securely held in place with a rear bracket

joining screws are included

The mount comes pre-assembled and you just need to remove the two back plates and then slot your devices in from the rear

The Amp slide into the frame from the front

The mount is designed to make use of the existing screw holes on the Edge Router and includes 8x M3 Screws

BMD Microconverter models supported:

Also includes a Keystone Port so you can add a keystone socket to route the Ethernet cable around to the front (Keystone Socket/Cable not included)

3D Printed 1RU rack mount for 3x BeeLink S12

The Sonos Ports slides into the frame from the front and you can either orientate it so the Cables come out the back or front