Corrosion of metals and alloys. Classification of low corrosivity of indoor atmospheres - Determination of corrosion attack in indoor atmospheres1 Scope This document specifies methods for determining corrosion rates with standard specimens of metals in indoor atmospheres with low corrosivity. For this direct method of evaluation corrosivity, different sensitive methods can be applied using standard specimens of the following metals: copper, silver, zinc, steel and lead. The values obtained from the measurements are used as classification criteria for the determination of indoor atmospheric

requirements for lifting loops were moved to ISO 12402-8:2020

4 mm up to and including 1 mm and in widths up to and including 1 250 mm

Water-borne type preservative solutions manufacturers

What is BS EN 16203 - Dynamic tests for lateral stability for counterbalanced lift trucks about

BS EN 14574 on pyramid puncture resistance of supported geosynthetics is useful for manufacturers of:

for use in drainage systems requiring a trap with a depth of water seal of at least 50 mm

The object of BS EN 61040  is to lay down definitions and minimum requirements as well as suitable test procedures for the characteristics and the manufacturing standards for detectors

one can measure the ability of a circuit breaker to sustain high-voltage differences without current breakdown

What is BS EN 3833 – Nickel alloy bolts for aerospace about

Test patchcord measurement – Method 1

ISO/TS 7637‑4 on electrical transient conduction is useful for:

What is BS 7494-2 - Analogue comparison system of power systems about