1985 Tach LCD Light DiffuserDiffusers broken or melted? Ours aren't! These clear plastic panels act as a light pipe, carrying light from the bulbs to the information areas of the LCDs. Unfortunately, the factory bulbs generate too much heat, and eventually melt the diffusers in the area where they surround the bulbs. Melted, bubbled or discolored diffusers can result in an image that's half as bright as one with proper, clear diffusers! It's also common for the small mounting

Precut and marked replacement matte finish polarizing film for the front and rear of the LCD panel

and is orange when using this kit

1 - Metal Oxide Varistor (PS Board)

or a 24V jump start

Note:  As of 9/2020

7V Zener Power Supplies don't work

They run cool to the touch

the cigarette lighter plug pictured is no longer available

Replacement Analog Calibration IC - top view

Our replacement LED bulb modules use modern electronics to step down the voltage

15 Crimp Terminals for 20-22ga wire

5: CR1 (D1 on early models)