Wiegand RFID Reader compatible with EM 125kHzWiegand RFID Reader compatible with EM 125kHz Cards. Control wires available for LED (Change from red to green) and Buzzer control. 6 pin connector is added to the reader for pairing with: HTD 008 A: 1 Wire Output Conversion Cable, DC to DC converter, Power Enable, LED and Buzzer Control HTD 009 A: UART TTL Output Conversion Cable, DC to DC converter, Power Enable, LED and Buzzer Control HTD 010 A: RS232 Output Conversion Cable, DC to DC converter,

HTD-010-A: RS232 Output Conversion Cable

The required drivers for the PC will install automatically once the USB cable is connected

26-bit cards only

and sends the ID to a 1-Wire interface utilizing iButton protocol

This accessory converts the output of a Wiegand RFID reader

(works with CalAmp products to display debug from AUX port)

9-pin J1939 Threaded Type I connector 'Y' cable to 15-pin HDSUB connector for CalAmp jPOD devices

14-pin RP1226 connector (PACCAR) to 15-pin HDSUB connector for CalAmp jPOD devices

12-pin dual row length of 1 meters (or 3

in length to give a total length of 2ft

3-pin single row LED connection

The UART Serial to Android Conversion Cable is specifically designed to work with UART/TTL level serial devices and connect directly to an Android tablet