2U Rack Mount for HUNSN RJO3 Micro Firewall Appliance (Modular)3D Printed 2RU rack mount for the HUNSN RJO3 Micro Firewall Appliance. The Firewall is securely held in place via the Backplate on the mount and there are also 2 Keystone Sockets on the faceplate for re routing rear ports to the front of the mount (Keystone Jacks not included). This is part of our ModMount Range, so you can mix and match your parts! NOTE: You will need to pair this with another ModMount item (Like some Blanking Plates) to make a full

This design was specifically made for the Clarett 4Pre

3D Printed 1RU rack mount for HP Elite (EliteDesk) or ProDesk Mini desktop PCs

The Sonos Port slides into the frame from the front and you can either orientate it so the Cables come out the back or front

The Elite slides into the frame from the back after removing the rear retaining plate

3D Printed 1RU rack mount for the Philips Hue Bridge v2

so if you don't see a mount for your equipment let me know and I can prioritize designing one for you

This mount also incorporates a 2 Keystone Sockets so you can use Keystone Jacks and Fly leads (Optional Extra) to connect your to Cable Modem from the front panel

Original centered design is still available here

Your NUC's will slide into the unit from the front and all cables are accessible from the rear

simply remove the rear brackets and slide your devices into place then screw the Rear Brackets back in

) 8 POE Switch into 1 RU

USW-Ultra-60W