Information technology. Automatic identification and data capture techniques. Bar code digital imaging and printing performance testing1 Scope This International Standard describes the characteristics and defines categories of bar code digital imaging systems, identifies the attributes of each system which are required to be controlled, and specifies minimum requirements for those attributes. It defines test methods for assessing the conformance of those attributes with this International Standard. It is intended to be used in conjunction with International Standards which detail the

BS EN 50378-3-1 specifies the dimensional requirements

BS EN 60604 provides a flash extender feature for the flashing of the lamps in the upper group

— fixed immersion heaters (IEC 60335-2-73)

It also provides test methods that help determine parameters such as extinguishing density and the maximum leakage area/volume ratio

These lug nuts are characterized by their smooth exterior finish and internal splines on the top of the lug that's requires a spline drive adapter for installation and removal

Measurement results obtained exclusively by the method described in this International Standard (see Annex A) cannot be used for an evaluation of vehicle stability because they deal with only one aspect of this very complex phenomenon

The corrigendum 1 corrects a value in 6

BS EN IEC 60332-3-22 on test for the vertical flame spread of vertically-mounted bunched wires or cables - category A is useful for:

Elastomeric parts Manufacturer

all dated references have been changed to undated ones

facilities and environments

Annex A (normative) Seal manufacturers' security-related practices