Injection equipment for medical use - One-point-cut (OPC) ampoules1 Scope This part of ISO 9187 specifies materials, dimensions and requirements for forms of one point cut (OPC) ampoules (forms B, C and D) for injectables. Ampoules complying with this part of ISO 9187 are intended for single use only.

The shank is reduced for better tension fatigue strength life

The tests may also be made individually for the study of a particular characteristic

BS 7161 on the specification for propeller shaft ends and bosses for inboard-engined pleasure craft is useful for:

Cellulose acetate moulding material is a thermoplastic composition in granular form capable of being shaped by heat and pressure

Two test methods are described: the "dichromate bleach test" and the "hydro­gen peroxide incubation test" (see [7] in the bibliography)

or reclining purposes

Using ISO 21013-4 you can specify the requirements for the design

Transportation – the need for temperature control/monitoring

Technical delivery conditions for flat products of high yield strength structural steels in the quenched and tempered condition

except that dimensions for accessory clamps have been specified to ensure interchangeability of accessories between tables

and the implementation is offered as open source in the OpenSIRF initiative

v) pigmented gelatine