RTS 5/32 N1/4 W 316 Stainless Steel Run Tee Push In FittingOperating Pressure Range 0 250 PSI (0 1650 kpa) Vacuum 0 30 Hg (760 mm Hg) Operating Temperature 5 230F ( 15 to 110 C) Recommended Tubing Material Polyurethane, Nylon, Polyethylene, Polypropylene, and Hard Metal Tubing (must be pre grooved) Body Material T316 Stainless Steel Release Button300 Series Stainless Steel Grip Ring or Collet 300 series Stainless Steel O ring Viton Thread Sealant None Service Air or LiquidSterilization Tempurature Up to 280F

Pressure Angle: 14-1/2 Degree

Click here for spec sheet: BUCTP Spec Sheet

USDA & FDA approved

Material: Cast Iron

Click here for spec sheet: HUCNPP Spec Sheet

Click here for spec sheets: SNATFL Spec Sheet

non-intersecting shafts

reinforcement braiding

Boston Gear’s stock helical gears are manufactured in both right- and left-handed configurations with an industry standard 45° helix angle to transmit motion and power between non-intersecting shafts that are parallel or at 90° to each other

Tee fitting with a tubing connection and male pipe thread on the run and a single tube connection

The units contain a mixture of both hardened steel and brass

are designed for connecting shafts at angles up to 30° for speeds up to 2000 RPM