Aerospace series. Zinc-Nickel (12 %-16 % Ni) plating of steels with specified tensile strength ≤ 1 450 MPa, copper alloys, nickel alloys and aluminium alloys for parts and fasteners1 Scope This European Standard specifies the plating of a Zinc Nickel (12 % to 16 %) alloy on mechanical parts and fasteners in steels (Rm 1 450 MPa), stainless steels (Rm 1 450 MPa), copper alloys, nickel alloys and aluminium alloys (not applicable for electrical components), as well as the passivation and lubricant finishing that can be associated to them. The Zinc Nickel process is an electrolytic plating process under controlled current allowing

In addition to the tensile testing machine previously described

you can demonstrate the reliability of your optical elements of unmated connections and build trust in its use throughout the aerospace supply chain

engineers and quality managers

This benefits all stakeholders of the periodical supply chain: publishers

This report is based on the result of a comparative study on existing methodologies published or under discussion in international organizations

BS 7000-4 on design management systems for construction is relevant to:

In this Technical Report the following aspects are taken into account:

Note: ISO 15186-3 is applicable in the frequency range from 50 Hz to 160 Hz but is mainly intended for the frequency range from 50 Hz to 80 Hz

BS EN 4604-002 provides requirements of materials

This part of BS 1566 specifies requirements for open vented

Note1: Sampling plans are not included in the scope ISO/TS 17728

BS EN ISO 21809-5 is applicable to concrete thicknesses of 25 mm or greater