j1939 Type 2 'Y' Splitter CableContact for volume pricing or to place special orders Cable provides three 9 pin j1939 Type 2 connectors that allow a device to be connected to the vehicle, and have the correct connector (either the threaded or square connector) to be installed in place of the vehicle connector. Each part of the cable is 1 ft. in length to give a total length of 2ft. All 9 pins are connected between the j1939 Type 2 connectors as a direct pass through to each

Equivalent cable for 5C994-2

Equivalent cable for 5C661

The table below shows the six connections that are mapped from the j1939 to OBDII

Note: Another variant of the cable is available to remove this functionality HTD-009-B1

3M in length

normally open configuration

14-pin RP1226 connector (Freightliner & International) to 15-pin HDSUB connector for CalAmp jPOD devices

RP1226 to J1939 converter cable mapping for 2019+ PACCAR vehicles with 250k CAN lines

Cable is 2 meters in length with 4 connections populated

Chain-able Temperature Sensor (DS28EA00) 30 inches in length

Pre-wired parasitic power 1-Wire temperature probe in stainless steel tube for single temperature probe applications

26-bit cards