Corrosion protection of steel structures by protective paint systems. Assessment of, and acceptance criteria for, the adhesion/cohesion (fracture strength) of a coating - Cross-cut testing and X-cut testing1 Scope This part of ISO 16276 specifies procedures for rating the resistance of coating systems when a cut in the form of a right angle lattice pattern (cross cut) or in the form of an X (X cut) is made into the coating, penetrating through to the substrate. This part of ISO 16276 is only applicable if the cross cut or X cut test method is specified, together with the rating from the appropriate rating scale. NOTE The characteristics of the coating

BS EN 15636 on shower trays of impact modified extruded acrylic sheets is relevant to:

It also includes test methods in which

construction industry

Camera equipment manufacturers

In this European standard

a representation of a hand is not included if the device is intended to be used next to the head or supported on or near the torso [73]

The definition of “specific case” – i

melt mass flow rate

The glass transition temperature is defined to be 170 °C minimum

This Technical Report provides a survey of some of the methods by which probabilistic risk assessment results can be used to establish "risk-based" classification criteria

and environmental samples that belong in food

it is possible to check not only the size of each guide pin hole but also the relative position and the relative angle between two guide pinholes