Tools for pressing. Matrixes1 Scope This International Standard lays down the basic dimensions and tolerances in millimetres for headless and headed matrixes, in the outside diameter range of 5 mm to 50 mm. It gives examples of material and hardness, and specifies a designation for matrixes that meet the requirements of this International Standard. The dimensions and tolerances of the matrixes specified in this International Standard are adapted to conform to those for punches

explained in BS ISO/IEC 15944-1

and minimum requirements for factory production control

group 4 now has a valid range of 260 °C to 360 °C and an updated precision

) are not detected by the method under ISO 5834-4

Manufacturers/producers of construction products

Field device tool manufacturers

BS 8524-1 specifies requirements for the design

Manufacturers of heat-resisting alloy wires

The standard is applicable to risk assessments being undertaken on premises

plaster of Paris (gypsum) moulding sets

Flange calculations

Methods A and B apply to the monitoring of all categories of the following fibres: