Pliers and nippers. Engineer's and "Lineman's" pliers. Dimensions and test values1 Scope This International Standard specifies the principal dimensions of engineer's and Lineman's pliers and the test values for the pliers in order to verify their aptitude to function in conformity with ISO 5744. General technical requirements are given in ISO 5743. The engineer's and Lineman's pliers illustrated in this International Standard are examples only and are not intended to affect the manufacturer's design.

Product development teams / innovation teams

BS 3463 is based on the requirements on the characteristics of glasses that had been shown to meet adequately the demands of service under conditions of high pressure and temperature in contact with corrosive fluids

This International Standard specifies requirements for an internationally acceptable series of boiling flasks with conical ground joints for general laboratory purposes

BS EN 10079:2007 replaces BS EN 10079:1993

this part of ISO 6361 specifies the mechanical properties of wrought aluminium and aluminium alloy sheets

engineers and quality managers

1 have been added

Why should you use BS EN 50655-3- For cold shrinkable components

This Technical Report applies only to driving and operating mobile machinery and not to performing other tasks (e

phomopsin A

acceptance and marking requirements for retreaded cross-ply tyres for use on aircraft operated under the jurisdiction of the UK Civil Aviation Authority

and provides examples of naming conventions